Aneman’s representation of the active devices and stream connections on my LAN is accurate when launched on Windows PCs (both Win 7 and Win 10), but the behavior is consistently inconsistent in the Mac Aneman instances. Hardware, e.g. Anubis, is recognized by Aneman-Mac, but stream connections are not always up to date, and there’s no “refresh network map” to prompt a rescan, unfortunately. In addition, the currently available Aneman for MacOS, downloaded today on a clean Catalina installation, refuses to display the presence of an active Ravenna VAD and connected Pyramix streams between a Win 7 machine and Anubis on the same LAN.
It’s a very simple private-addressing network here with a Cisco 350 switch configured per Ravenna/Merging recommendations, one dual-boot Windows 10/Mac OS PC (Pyramix Native), one additional MacBook Pro (Ravenna VAD) and one Windows 7 PC (Pyramix Native). Audio flows fine in all directions. Despite only one Aneman instance open at a time, the issue is observing the routing from a Mac.
Have you observed any similar behaviors? Any suggestions for reconciling these discrepancies?
“Refresh map” is a feature request I’d recommend for Aneman Mac.
Best regards,
Aneman (Mac) vs. Aneman (Windows)—Discrepancies?
Forum rules
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
If you need assistance please contact tech support.
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
If you need assistance please contact tech support.
Aneman (Mac) vs. Aneman (Windows)—Discrepancies?
Michael Fleming
Sonaura Sound
Dept. of Recording Industry
Middle Tennessee State University
Murfreesboro, TN
Sonaura Sound
Dept. of Recording Industry
Middle Tennessee State University
Murfreesboro, TN
Re: Aneman (Mac) vs. Aneman (Windows)—Discrepancies?
Make sure both Aneman are same version (on PC and MAc) and MAD / VAD drivers are the latest for both systems (OSx and Win) too. Use dynamic IP address for all interfaces an try using the provided merging cisco 350 preset file , available in the confluence page.
Hope it goes well.
Hope it goes well.