Hi guys,
this has probably been suggested before, but I think only in relation to WAV files: after making a CD image I wanted to find the peak. After creating the waveform and finding the level a little low, I deleted the image and created a new one - this however still showed the same level. I did this a number of times but it was always the same. It was not until closing the project and re-opening that it showed the correct value.
Perhaps it would be possible to show the peak after a mixdown or image-creation, and perhaps create the waveform during mixdown?
Cheers,
Tom
Showing peak after mixdown/making image + bug
Forum rules
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the tech support request form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the tech support request form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
-
Thomas Grubb
- Posts: 275
- Joined: Fri Feb 10, 2006 02:20
- Location: Melbourne, Australia
- Contact:
Showing peak after mixdown/making image + bug
Thomas Grubb
manomusica.com
Melbourne
manomusica.com
Melbourne
-
Thomas Grubb
- Posts: 275
- Joined: Fri Feb 10, 2006 02:20
- Location: Melbourne, Australia
- Contact:
