Merging Anubis not showing up in ANEMAN
Posted: Fri Jun 25, 2021 01:16
First time ravenna user here.
On initial setup of my merging anubis pro, I installed the MAD driver for the device. This also automatically installed aneman. However, I do not see the anubis in aneman. Oddly so I see the anubis in the MADPanel yet cannot "unite" with the device. I get the " You need to select at least one IO in order to unite" error upon attempting to setup the device. The anubis' webpages will not load.
I am using windows 10, firewall off. Firmware 1.1.12. Not sure what I am missing.
On initial setup of my merging anubis pro, I installed the MAD driver for the device. This also automatically installed aneman. However, I do not see the anubis in aneman. Oddly so I see the anubis in the MADPanel yet cannot "unite" with the device. I get the " You need to select at least one IO in order to unite" error upon attempting to setup the device. The anubis' webpages will not load.
I am using windows 10, firewall off. Firmware 1.1.12. Not sure what I am missing.