Hi everyone. Today i´ve updated my anubis to the latest firmware ( version 1.1.12b45672).
Since there was a note on the update page about the noise (Fixed. High noise level measured not audible on Dual PreAmps input) i took some time to make measurements.
Using voxengo span plus i setup the low range to minimum value (-180dBFS) and i could visualize that in Combo XLR 1 and 2 i have some noise level around -130dBFS (Pre) and -144dBFS (Line) (white noise) - Nothing is connected to this inputs -
Front Inputs 3 and 4:
On input 3 shows -144dBfs noise (for Instrument and Line) Plus a 10KHz harmonic (?) - Nothing connected -
On input 4 shows nothing, cristal clear zero signal. - Nothing connected -
I leave here some screenshots so you can see it.
LINK to Screenshots
Thanks