Hi,
It seems that pyramix has a problem with the ltc signal from a A&V timecode generator? this generator has some additional information in the tc signal, wich is ignored by all our other (betacam, evs) machines, but pyramix only sees ltc every half second or so, and loses the signal in between..
Is this a known problem?
alpermann & velte timecode generator
Forum rules
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the tech support request form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the tech support request form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
alpermann & velte timecode generator
Huub lelieveld
Senior audio engineer
United outside broadcast
Euro Media Group
Hilversum, Netherlands
PMX v8.1
Mykerinos X-30 D, Triple DC MADIO-2 Optical Madi
Senior audio engineer
United outside broadcast
Euro Media Group
Hilversum, Netherlands
PMX v8.1
Mykerinos X-30 D, Triple DC MADIO-2 Optical Madi
-
bodo.biber
- Posts: 19
- Joined: Sun Jun 08, 2003 16:34
- Location: Starnberg / Munich / Germany
Hi,
some time ago I had problems with proper timecode reading too. It was a different setup with pyramix feeding its LTC into an external machine. The dropouts you describe sound similar to the ones I had. In my case the problem was that the volume level of the signal was a bit too low. By increasing the level the problem was gone. I´m not sure if this helps in your case, but maybe it´s worth a try.
regards,
rainer
some time ago I had problems with proper timecode reading too. It was a different setup with pyramix feeding its LTC into an external machine. The dropouts you describe sound similar to the ones I had. In my case the problem was that the volume level of the signal was a bit too low. By increasing the level the problem was gone. I´m not sure if this helps in your case, but maybe it´s worth a try.
regards,
rainer