Merging Technologies

I believe merging is aware of this and maybe this month we´ll have a firmware update correcting this problems.

Its worth checking system compatibility before going for a new purchase!
i guess you´ll have to wait a few months for your system to work.

Did you change the instrument and line input in the Anubis ? either in the web page or the Anubis LCD settings page ?

Indeed there is more noise on Combo 2 with both (mic 1 and mic 2) on.
I made a screenshot LINK

And here is a link to the Built in Microphone noise i have with my Anubis:
Does anyone have it too ?
I tried different sample rates and always the same.
LINK

Bertram wrote:Confirm both issue here also. Firmware 1.1.8b44345
Noise is about 4 db more on channel 2
Talkback mute if channel 1 is on boost.

you still running on the previous firmware, try updating

I confirm this issue here on my Anubis too.
Boost ON in channel 1 makes TB mic silent dead.

Latest firmware 1.1.12b45672

Hi everyone. Today i´ve updated my anubis to the latest firmware ( version 1.1.12b45672). Since there was a note on the update page about the noise (Fixed. High noise level measured not audible on Dual PreAmps input) i took some time to make measurements. Using voxengo span plus i setup the low rang...

For me all routing is ok. I ve tested with Reaper and all good.
Are you doing all in ANEMAN ? you need to first create the propoer settings in MAD.
Check this : https://confluence.merging.com/pages/vi ... d=73662784

It will depend on how you have your latency settings setup.
If it's very low (about 2ms) maybe you wouldn't notice.
That s my guess
Did you try disabling thev input monitor of your DAW for the vocal. Channel?

Hi everyone, is it possible to send from laptop 1 a stream of LTC to laptop 2 over a DANTE - Anubis network ?
The main purpose is to have two machines running ableton live in sync from an x32 with dante card to laptop2 using Anubis for sync purposes of ableton live session.

Thanks

Turn off input monitor in the DAW for you voice, just listen to the direct monitor. Otherwise you´ll be listening two signals instead of just one. Is that the case ?

One thing you can do is use the web page of the hapi (check what is your ip for the Hapi device and place that in your briwser) from there you can controlor all in/ out /routing.

One thing i´ve learned from this forum is that there is no one to answer you, and when there is, they say " Check the merging confluence page" or "contact your local distribuitor"...its a very "poor" way of dealing with customers (imo) that spend a couple thounsands in ...

I think that will mostly depend on microsoft not merging. Since Microsoft has code made for ARM arquitecture for some time , only time will say if they want it or not.