Sliding multiple automation points

Welcome to the Pyramix MassCore discussion forum.
Forum rules
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the tech support request form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
Posts: 3
Joined: Fri May 16, 2014 00:27

Sliding multiple automation points

Postby mogers » Tue Feb 24, 2015 15:52

Hi all

Does anyone know if there is a way to select multiple automation points and then slide all of them left or right? I know that I can click on a single point whilst holding down H and slide that solitary point back and forth, but can it be done with more than one point? Cutting from the old position and pasting at the new position seems an inelegant faff, as does moving each point individually.