Merging Technologies
Welcome to the world of Pyramix, VCube, Ovation, Horus & Hapi - The forum with a higher signal to noise ratio!
Control Plugin from Ramses
Forum rules
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the bug reporting form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
The Merging Technologies team cannot be held responsible for support queries logged on the public forums. If a support query is logged here and only here, it may not be found and dealt with by the appropriate team.
To ensure that your support issue or bug report is dealt with properly and in good time, please use the link to the bug reporting form page on the Merging website.
Make sure to let us know what version you are using when you send your mail. THANKS!
2 posts
• Page 1 of 1
Control Plugin from Ramses
by J.Wajer » Wed Nov 18, 2009 12:31
I use striptools and EQ-x and I set EQ-x on the Ramses as preferrd control. (Select Plugin - Control). But everytime the mixer rebuilds, it looses control over the EQ-x. Is there any workaround so that I wont need to set control each and every time?
...Gracefully Ignored...
-
J.Wajer - Posts: 1679
- Joined: Tue Dec 18, 2007 10:25
- Location: Amsterdam, Netherlands
Re: Control Plugin from Ramses
by J.Wajer » Thu Nov 19, 2009 14:38
Turns out that setting the EQ-X as the first (upper) plugin on the stripchains overcomes this rebuild loss-of-focus.
...Gracefully Ignored...
-
J.Wajer - Posts: 1679
- Joined: Tue Dec 18, 2007 10:25
- Location: Amsterdam, Netherlands
2 posts
• Page 1 of 1
Return to Merging Controllers (Ramses MSC - Isis)
Who is online
Users browsing this forum: No registered users and 2 guests