Page 1 of 1
Can't see either UBMadi or Lynx Aurora
Posted: Thu Feb 25, 2016 06:36
by trumpetlore
I'm a bit of a novice user so I'm hoping I can get some help here. I've purchased pmx 10, I have an Aurora 16 that I'm trying to connect to Pmx with over USB. I can connect and get signal on Reaper (downloaded just to check) but I can't see either of my asio devices on MT Discovery or Ravenna Easy Connect.
Any advice would be greatly appreciated! I need to get this solved by a recording gig March 6.
Re: Can't see either UBMadi or Lynx Aurora
Posted: Thu Feb 25, 2016 09:24
by klaukholm
MT Discovery and Easy Connect are for AES67 and Ravenna only.
You need to open the VS3 Control Panel and follow the instructions in the manual. If you purchased PMX10, you have one year ASM (annual support) and your dealer should be able to get you going if you are having problems.
Re: Can't see either UBMadi or Lynx Aurora
Posted: Thu Feb 25, 2016 10:36
by DJS
Yes, just open VS3 Control Panel and select your Lynx ASIO driver as your sound card for PMX10. The VS3 control panel app is where you link your recording sound card with PMX.
Re: Can't see either UBMadi or Lynx Aurora
Posted: Thu Feb 25, 2016 16:41
by trumpetlore
Good to know that I won't use MT or Easy connect
Already had it selected on vs3. Pmx boots at the end of creating my session, just before it actually creates it.
Re: Can't see either UBMadi or Lynx Aurora
Posted: Thu Feb 25, 2016 17:53
by trumpetlore
Just fixed it. It was a latency setting on the aurora causing the issue.